[Ducati] Strange Clutch Problem

[Dave A.]

On my 748 there is an adjuster on the clutch lever-  the little pushrod 
which is attached to the lever can be screwed in and out to adjust 
clutch engagement.
Mine has a locking set screw in the barrel on the clutch lever- hope 
this helps!

-Dave

>Went to go for a ride today on my 2K M900ie and the bike would lurch and  
>stall upon being put into gear.  With the clutch pulled in the it  would not roll 
>forward (or backward for that matter) without a good hard  push.  It would 
>shift into neutral and would roll just fine in  neutral.  Worked fine a few days 
>ago when I rode it home from the shop  after having an oil leak on the timing 
>belt lay shaft repaired.  Has a new  clutch in it with about 1000 miles since 
>the clutch replacement.  Any  ideas?
> 
>I checked the clutch fluid--no air in the line and plenty of fluid, no  
>leaks.  The pressure plate moves in and out like it should when I release  and pull 
>in the lever.  We rolled the bike forward in gear to see if there  was an 
>issue with stuck plates and all it did was turn over the engine.   The engine 
>runs just fine in neutral.
> 
>I am baffled.
> 
>Syl S.
>2K M900ie
>84 GPz550
>  
>