[Ducati] New Barnett clutch- adjustment?

[Garth Williams]

Hmmm, the Dryflex clutch only uses one dished (they call it curved) 
plate. Now, if I've got it installed backwards, that could be part of 
the problem.  I'll switch it and see, as it doesn't exactly take much 
time. 


Garth

mike major wrote:
> The curved, or dished, plate, if placed on a flat surface (I use a glass coffee table) will allow a feeler gage to slide under the inside of the plate while the outside is in contact with the glass.  My clutch uses two dished plates placed with the dish side towards the center of the clutch basket.  According to my manual some models use only one dished plate near the inside of the pack with the dished side to the center of the pack.  I hope this helps, I re-installed my slipper clutch with several combination of plates before finding the setup that works for me.  Later, Moonbeam
>   
>