[Ducati] CycleCat DTC-1 Questions

[mo+omille]

I have some questions from any of you that have done the 900SS  
Superbike front fork swap out there.

I purchased the DTC-1 triple for my 900SS (1996) project some time  
ago... I haven't gotten around to swapping the forks until this  
weekend and I have to say I'm surprised!

1.  They quality on the product is excellent... perfect in every way.
2. The installation instructions sucked... there were 2 steps.. super  
vague.  With the quality and beauty of the products you would think  
Cycle Cat might put the same effort into the instructions... pictures  
would help too.
3.  There's nothing about the next steps...

Will I need to use a superbike bottom axle?
Can the SS axle be used?
Will I need to use a superbike front wheel?
If I do use a SS front wheel can I use different bearings and a spacer?
What part number are the bearings?
Do you sell the bearings?
Do you sell the spacer?
Can I use my SS speedo gear/spacer?
Do I need to use a Superbike Speedo/spacer?
Will my SS brake calipers bolt right up?
Will my SS brake rotors bolt right up?


These are all the questions I have.

Currently I have the 996 forks installed in the triples... it fits  
perfect and looks even better!
I put the 996 axle and a 996 front wheel on it... but I haven't  
tightened it down... Is the spacing correct?
If I tighten the axle will it bend my fork tubes?  Damage the forks?   
Or do I have to use my SS front wheel with different bearings?

Thanks for all your help.

Pete

P.S.  I sent the same questions to Cyclecat... figured I would ask  
"the audience" these question too.