[Ducati] 999 Power Commander maps

[Izaak]

I've found that it doesn't help much to use someone else's map, even 
if they have a very similar bike (odd to find an identical one).

The only way to get a proper map is to dyno it and have it set up that way.

rgds

At 05:11 PM 7/31/2006, you wrote:
>Hi,
>
>Second, does anybody have a link for some PowerCommander III USB maps
>for an '03 999 w/ Silmotor full system & DP air filters?
>
>In SF, my temp gage pretty much never gets above about 160 degrees
>F., so the ECU warm-up mode's enrichened mix was fine for
>driveability, mostly.  That is, until last week, when I installed a
>set of Ducati Performance air filters which leaned out the mix enough
>to make the bike run a bit rough, and then rode to Laguna and back
>(through that serious heat Sunday) to Oakland. So, I bought a
>PowerCommander III-USB at Laguna to get the fuel-air mixture sorted.
>Thing is, I have a non-typical, Silmotor 55-60mm full 2-1-2 system,
>so finding maps online is not happening sofar. Best match I can find
>is based on European models in Germany. Anybody know of a good map to
>start my tuning from, and if the ECU and fuel/air mixture for EU
>models are the same as for USA models?